![]() The programmer on X1 should light up.Ĭlick on “Program”, after successful programming it should look like this: Plug in the USB cable and turn on the power of the UltraZohm. Note that it is possible to program only one of the CPLDs by the enable check box in each line. Start the Diamond Programmer by Lattice and open the file in the git Programm_all5_CPLDs.xcfĬhose the proper CPLD software and chose which CPLDs you want to program. This step is not necessary for Rev04 and later. Have all jumpers on the Carrier Board plugged on to X2 to create the daisy chain. ![]() Make sure that the hole in the programmer aligns exactly with the mounting hole on the carrier board. Set the DIP-switches S2 on the programmer to (1on-2off-3off-4off). ![]() Remove the programmer (normally used for programming the Zynq) from X8 of the Carrier Board. Install the Diamond Programmer by Lattice and clone the CPLD repository, see Install Lattice Toolchain (CPLD) for details.
0 Comments
Leave a Reply. |